LashPOP
  • Home
  • How To
  • Contact
  • Shop
  • Home
  • How To
  • Contact
  • Shop
Search
Before applying your Strip Lash you need to make sure they properly fit. If you do not know how to adjust them please review this guideline:

Prepping Your False Eyelashes

Most likely your lashes will need to be trimmed to properly fit your eyes.  You do not want the lashes to be too long, it will make the eyes look droopy.  For best results, 5 or 6 of your natural lashes should be left over on both sides of where the strip lash lies.  As a general rule, the lashes are longer on the outer part of most strip lashes and that is the side you should trim from.

Step One

Gently remove the strip lash from its packaging, start from the outer part and wiggle back and forth.
Picture

Step Two

Measure the lash on your eyelid. The outer lash will overlap trim it so that 5 or 6 of your natural lashes are on both sides. Also be sure to trim any of the Band that does not have any lashes on it and can poke out.
Picture

Step Three

The final result is that the strip lashes are not too long, and does not go over your natural lash line. After that, You are ready to glue on your lashes.
Picture

Now, to Glue Them On

Our glue sets give you the best results because they have three unique components that make the lashes go on and stay on. safe, easily and comfortably.  All three come in each glue set.
BAND BLENDER
5ml/.17oz
Picture
Show in Brown
- Softens and conceals the strip.
- Comes in six (6) different rich colors
- Adds definition and naturally fills in the gaps
- Blends everything together so no extra steps are needed

Band Blender is applied to the entire Lash Band - top bottom, sides and front.
Picture
BASE AND SEAL
​5ml/.17oz
Picture
100% Vegan and Cruelty Free
- Uniquely formulated with pure vegetable resins
- Creates barrier preventing friction between strip lash and eyelid
- Helps guide the strip on and holds it in place

Goes on your lash line like you would an eyeliner can go right over make up.
GUAR GLUE
​5ml/.17oz
Picture
- Water based, latex and toxin free
- Excellent hold and movement
- No shine
- Corners stay down for entire wear
- Do not have to wait for it to tack
- Ample time to maneuver and set strip lash

Apply a small amount to the front only after band blender is dry.
Just follow these simple steps
** ONE IMPORTANT TIP**
Applying the glue is the final step and the Band Blender must be completely dry before doing so- you can dab it on a tissue or the back of your hand to make sure it is entirely dry.
Picture
Important Tip:  Band Blender must be 100% dry before the glue step

​Contact Us

Picture

Shop Online

Picture

About

Picture
Proudly powered by Weebly
  • Home
  • How To
  • Contact
  • Shop